Hardy HI 4050, User Manual

Page: 30 / 192

20 Chapter 3
•
•
•
•
•
•
DIN Rail Installation HI 4050 Weight Controller
Step 1. Snap the two DIN rail mounting feet
(shown on right) into the two holes on
the front panel of the electronic
enclosure appropriate for the desired
mounting orientation.
Step 2. When installing, push the mounting feet until you hear a snapping sound. The
snap means they are mounted correctly.
Step 3. After installation, check each mounting foot to ensure it is seated correctly.
CAUTION: If you do not hear a snapping sound, the mounting feet are not mounted correctly and
the instrument may be loose, which may interfere with other electrical equipment or
wiring.
ATTENTION Si vous n’entendez pas un claquement, cela signifie que les pieds de l’appareil ne sont
pas installés correctement et l’instrument n’est pas stable, ce qui peut provoquer des
interférences avec les autres équipements électriques ou câblage.
There are several horizontal and vertical mounting options. It is required that at least two
mounting feet be used per enclosure.
Step 4. To mount the enclosure onto a DIN rail, place the mounting feet on the DIN Rail
and firmly press down until the mounting feet snap onto the rail.
Remote Display Installation
Step 1. Install the Electronic Enclosure on a DIN Rail or in a panel within 100 feet (30.5
meters) of the remote display.
Step 2. Use any 6 wire, shielded cable (Minimum 22 AWG).