30
Chapter
3
•
•
•
•
•
•
Step 4.
Use the four 6-32 x .1875 Phillips pan-head screws to fasten the rear panel to the
electrical enclosure.
Step 5.
Use a torque screw driver and torque each screw to 10 inch/pounds. DO NOT
OVERTIGHTEN!
Step 6.
To disassemble the printed circuit board assembly, reverse Steps 1-5.
Installing Option Cards
The option cards connect to the Main control board either from the network header or
option slot header. Each card is installed the same way in either the Network slot or the
Options slot, except as noted. This applies to the following cards:
•
DIO (options slot)
•
Analog Output (option slot - 4ANB) or (network slot - 4ANA)
•
Profibus (network slot)
•
DeviceNet (network slot)
•
ControlNet (network slot)
•
RIO (network slot)
CAUTION:
Always protect printed circuit boards from electrostatic discharge (ESD). Always use approved
ESD wrist straps and anti-static pads.
ATTENTION
Toujours protéger les circuits imprimés provenant de décharges électrostatiques (ESD).
Toujours utiliser les straps ESD approuvés et tampons anti-statiques.
Installing a Card in the Option Slot (applies to -4ANB and -DIO)
Installing the Cards
Step 1.
Plug the Board Stacker into the Option Slot Header (J9) on the Main Controller
board, as shown below.
NOTE
Be careful not to bend the pins when plugging the Analog Board into the board stacker.
Summary of Contents for HI 4050
