Happy HCS2-1201-30, Maintenance Manual

Page: 176 / 196

16 8
6-2-3 Trouble shooting (Erroneous thread cut)
Trouble Factor Cause of trouble and measure
Page
Erroneous
Mechanical
1. Is thread cut timing proper?
thread cut 1-1 Set timing to specified value. 3-6-3
(E-190) 1-2 Check no loosening of screw on thread cut cam.
(E-193) 2. Isn't rubbing of fixed knife and moving knife weak?
2-1 Adjust to be able to rub properly. 3-6-6
3. Does moving knife make smooth move?
3-1 Check if rubbing of moving knife and fixed knife is not too strong.
3-6-8
4. Check Displace of moving knife.
4-1 Adjust of moving knife position. 3-6-9
5. Check defacement of moving knife or fixed knife.
5-1 If possible, furnish with file.
5-2 Replace
3-6-6 and
3-6-7
6. No backlash in up and down direction of knife drive shaft?
3-6-8
6-1 Check no loosening of screw on moving knife.
6-2 Check no loosening of screw on knife drive shaft.
7. No backlash in fixed knife?
3-6-8
7-1 Check no loosening of screw on fixed knife.
8. Does thread cut solenoid work properly?
8-1 Check cable.
8-2 If trouble found in CONT board, replace.
8-3 If trouble found in thread cut solenoid (or motor), replace.
9. No trouble in thread cut drive?
9-1 If thread cut roller broken, replace.
3-6-2
9-2 If roller screw gets loosened, tighten firmly.
10. Is number of revolution proper at time of thread cut?
10-1 Make automatic speed setting.
4-4-5
10-2 If trouble in CONT board, replace.
11. Is there no skipped stitch?
11-1 Adjust needle depth.
3-3-6
11-2 Adjust clearance between needle and rotary hook. 3-5-1
11-3 Is height of pressure foot proper? 3-2-10
11-4 Is rotary hook timing proper? 3-5-1
11-5 Is relation between needle and thread proper?
( ) ---Reference instruction book