PRINTED IN U.S.A.
503-1
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
907871E
Template Date: 1997_02_12
RS5-34 Telescopic Handler
FRONT AXLE
GENERAL INFORMATION
If steering cylinder, brakes or differential repairs are
required, the axle assembly must be removed from
the chassis. If only axle steering knuckle or outboard
planetary service is required, the axle assembly will
not require removal from the chassis.
Procedures used to remove the axle will depend on
machine location and the type of lifting equipment
available. The following axle removal and installation
procedures, using two 10-ton hydraulic bottle jacks
for lifting the machine, and a 5-ton floor jack to lift and
lower the axle assembly, can be done in the field or in
the shop. The machine must be parked on a solid
and level surface.
FRONT AXLE REMOVAL
STEP 1
G0905059
Level the frame according to the frame level indicator
located in the operator’s cab.
MANDATORY SAFETY SHUTDOWN
PROCEDURE
BEFORE cleaning, lubricating, or servicing this
equipment:
1. Bring the machine to a full stop on a level
surface. (If parking on a slope or hillside cannot
be avoided, park across the slope and block the
tires.)
2. Fully retract the boom and lower the attachment
to the ground.
3. Place controls in NEUTRAL and set the park
brake.
4. Idle the engine for gradual cooling.
5. Turn the keyswitch to OFF position and remove
the key. (Take the key with you for security
reasons.)
ONLY when you have taken these precautions
can you be sure it is safe to proceed. Failure to
follow the above procedure could lead to death or
serious injury.
G0805077
RELIEVING HYDRAULIC PRESSURE
1. Fully retract the telescoping boom.
2. Raise the telescoping boom far enough to be
able to remove the axle from under the frame.
3. Turn the keyswitch to the OFF position to shut off
the en gi n e. (See a bove M an da tor y Sa fety
Shutdown Procedure.)
4. Move the frame leveling joystick several times to
relieve hydraulic pressure in that circuit.
WARNING
Tires may be filled with liquid ballast. If filled
w i t h l i q u i d b a l l a s t , t h e w h e e l s w i l l b e
extremely heavy. To prevent injury, remove
ballast or use proper tire handling equipment
when dismounting the wheels from the axle
hubs.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com