RS5/6-34 Telescopic Handler
HYDRAULICS
PRINTED IN U.S.A.
601-41
913241/BP0508
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
0-00000
Template Date: 1994_04_22
STEERING CIRCUIT PRESSURE QUICK
TEST
STEP 98
G0805193
Install a 5000 psi (345 bar) pressure gauge and hose
on the SP test port of the flow divider.
NOTE:
The hose must be long enough to observe
the pressure gauge from inside the cab or standing
clear of the forklift.
STEP 99
G0805078
Start the engine and run at 1000 RPM. Move the
Steer-Mode Switch (1) to the 4-Wheel-Steer position.
Turn the steering wheel in one direction until the
wheels reach their travel limits and hold. The
pressure gauge should read 2000 psi (138 bar).
If the pressure is less than 2000 psi (138 bar),
proceed to the next step.
If the pressure is 2000 psi (138 bar), but the steering
does not work properly, check the steering linkage
and pivot points, and the Steer-Mode Valve, before
repairing or replacing the steering control unit.
If the pressure is more than 2000 psi (138 bar),
replace the flow divider.
STEP 100
G0805077
Tilt the frame to the right until the frame leveling
cylinder reaches the end of its stroke and hold. The
pressure gauge should read 2000 psi (138 bar).
If the pressure is less than 2000 psi (138 bar) go to
the Pump Pressure Test in this manual.
If the pressure is 2000 psi (138 bar), proceed to the
next step.
STEERING CIRCUIT PRESSURE DIRECT
TEST
STEP 101
G0805193
Shut off the engine. Remove the pressure gauge
from the SP test port.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
