RS5-34 Telescopic Handler
BOOM ASSEMBLY
PRINTED IN U.S.A.
701-3
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
907871E
Template Date: 1997_02_12
G0805102
8. Locate the attachment Boom Retract section
(third section) on the right side of the control
valve and remove the rubber boot. Using a
screwdriver, turn the screw IN (clockwise) until it
bottoms, then turn it OUT (counterclockwise)
until it bottoms. Reinstall the rubber boot.
STEP 2
G0805199
G1005029
Loosen and remove the four bolts (1) and the rear
cover (2).
Bolt two OEM 4129, 4000 lb. Lifting Brackets (3) (or
equivalent) to the top rear of the outer boom section.
STEP 3
G1005027
Connect two equal length chains to the lifting links.
Apply upward pressure with an adequate size hoist
until the chains are tight.
NOTE:
If only the boom pivot shaft is to be replaced,
it will not be necessary to disconnect any hydraulic
lines or lift cylinders from the boom. Connect an
overhead lifting device to the rear of the boom. Use
the lifting device to take up the weight of the boom
from the pivot shaft. Remove the pivot shaft retainer
bolt from the end of the shaft. Use a large brass drift
and heavy sledge hammer or a hydraulic ram pusher
arrangement to drive the shaft approximately half
way out.
Lubricate the new pivot shaft with anti-sieze grease.
Install the new shaft into place. Using the old pivot
shaft as a pilot, install the retainer bolt and nut.
1
2
3
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
