RS5-34 Telescopic Handler
BOOM ASSEMBLY
PRINTED IN U.S.A.
701-2
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
907871E
Template Date: 1997_02_12
RELIEVING HYDRAULIC PRESSURE
FOR THE TILT CYLINDER
1. Remove any attachments from the boom.
2. Fully retract and lower the telescoping boom on a
support stand.
3. Turn the key switch to the OFF position to shut
down the engine. (See above Mandatory Safety
Shutdown Procedure.)
G0805076
4. Remove the rear hood to allow access to the
main control valve.
G0805101
5. Locate the attachment Tilt Up section (rear
section) on the left side of the control valve and
remove the rubber boot. Using a screwdriver,
turn the screw IN (clockwise) until it bottoms,
then turn it OUT (counterclockwise) unti l it
bottoms. Reinstall the rubber boot.
G0805102
6. Locate the attachment Tilt Down section (rear
section) on the right side of the control valve and
remove the rubber boot. Using a screwdriver,
turn the screw IN (clockwise) until it bottoms,
then turn it OUT (counterclockwi se) until it
bottoms. Reinstall the rubber boot.
RELIEVING HYDRAULIC PRESSURE
FOR THE BOOM EXTEND CYLINDER
G0805101
7. Locate the attachment Boom Extend section
(third section) on the left side of the control valve
a n d r e m o v e t h e r u b b e r b o o t . U s i n g a
screwdriver, turn the screw IN (clockwise) until it
bottoms, then turn it OUT (counterclockwise)
until it bottoms. Reinstall the rubber boot.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
