SOFTWARE MANUAL C32
11.4.5 DISTANCE ToF TO BLACKMARK
Parameter 18,16
This parameter determines how far the printer continuously prints after blackmark detection before the ticket terminates
after a form feed. Thus, the blackmark does not necessarily have to be located at the beginning of the ticket. With this
parameter the blackmark can be "shifted".
11.4.6 NUMBER OF TICKET SEGMENTS
Parameter 18,17
This parameter specifies how many segments (blackmarks) a ticket contains and ticket groups can be generated.
Normally data exceeding the physical ticket will be cut off (clipped). In the setting: 0 ticket data will not be clipped.
=0:
each blackmark is used but can be overwritten.
Ticket data will not be clipped at =0
=1:
each blackmark is used, too long printouts are cut
=2:
every 2nd blackmark ...
11.4.7 DETERMINE TICKET LENGTH
Parameter 18,39
Ticket length is stated in 1/10 mm and should be set to approximately 1.5 to 2 times the label length.
Ticket length can span several blackmarks (see
parameter 18,17
).
11.4.8 BLACKMARK SEARCH LENGTH
Parameter 18,40
Indicates how long (minutes) the printer is supposed to search for the blackmark after end of ticket.
The parameter is set to "0" when the ticket mode is used according to length without blackmark.
11.4.8.1 MINIMUM BLACKMARK SEARCH LENGTH
Note: until a blackmark is accepted
Parameter 18,41
If the printer sensor is placed on a mark after a ToF, the next ticket would immediately detect a new blackmark situation.
This parameter defines the number of mm that have to be searched for a blackmark before accepting it.
11.4.9 DELAY OF PAPER END DETECTION
Parameter 18,27
This parameter is used to define how many paper end lines must be recognized to initiate a paper end condition. A paper
end error will be cleared after paper is detected. For this purpose, no line feed is necessary. When using blackmark control
by paper end sensor, too high a value leads to a delay in paper end message.
GeBE Elektronik und
phone
+49.89.894141-0
GeBE-document-no. SoMAN-C32-E-V2.2-0793
Feinwerktechnik GmbH
fax
+49.89.894141-33
date
July 7, 2020
Beethovenstraße 15
page 85 | 166
82110 Germering
Our general terms of business are to be applied.
Germany
Internet
www.gebe.net
Errors and changes reserved.
