SOFTWARE MANUAL C32
16.7.2 VALUE MODIFICATION DESIGNED TO USER SPECIFICATIONS
[Command identifier]
SyspModify
[1. Parameter]
System parameter identification (wildcards not tolerated)
[2. Parameter]
New value
[3. Parameter]
Storage area:
•
UEEP: EEPROM (permanent storage)
•
URAM: RAM (volatile storage, non permanent value)
[4. Parameter]
This parameter is needed in special cases only. If not needed the new value is activated, if
permitted by access rights (see above).
Boolean, optional:
•
T: with activation
•
F: without activation
[Description]
This command changes the value of a system parameter. If the access rights are not met an
error message is released and the command will not be executed.
System parameters are organised in module groups. If a system parameter value designed to
user specifications is filed in the EEPROM, a complete set for this module is created in the
EEPROM on the basis of ex works default values.
Data filing in RAM without activation or storage in the EEPROM is not reasonable.
16.7.3 COPYING SYSTEM PARAMETERS
This command copies a system parameter value from source to target storage area.
[Command identifyer]
SyspCopy
[1. Parameter]
System parameter identification
tolerated wildcards:
•
0,0:
all system parameters of all modules
•
x,0
all system parameters of module x
[2. Parameter]
Source
•
FIRM:
firmware parameter
•
FACT:
factory parameter
•
UEEP:
parameters designed to user specifications in the EEPROM
•
URAM:
RAM
[3. Parameter]
Target
•
UEEP:
parameters designed to user specifications in the EEPROM
•
URAM:
RAM
[4. Parameter]
This parameter is needed in special cases only. If not needed the new value is activated, if
permitted by access rights (see above).
Boolean, optional:
•
T: with activation
This should be avoided if wildcards are used for system parameter identification,
because not all module system parameters suffer activation during operation. (Error message
and suppression of command).
•
F: without activation
GeBE Elektronik und
phone
+49.89.894141-0
GeBE-document-no. SoMAN-C32-E-V2.2-0793
Feinwerktechnik GmbH
fax
+49.89.894141-33
date
July 7, 2020
Beethovenstraße 15
page 127 | 166
82110 Germering
Our general terms of business are to be applied.
Germany
Internet
www.gebe.net
Errors and changes reserved.
