SOFTWARE MANUAL C32
Module 22
Cutter
22,1
e_a
maximum cutter motor speed [pps]
22,2
e_a
half cut: number of pulses
22,3
u_w
distance from dot line to cut [dot lines]
22,4
u_a
TRUE: always move cutter blade to home position on init command
FALSE: move blade only when out of home position
22,5
e_a
micro step resolution: 1...8
22,6
e_w
motor current: 0...31
(hardeware dependent)
22,8
u_a
full cut number of steps
22,9
u_a
allow paper movement when retracting blade after cut
22,10
e_w
cutter motor starting speed [pps]
22,11
e_w
acceleration: number of steps
Modul 23
Winder
23,1
u_a
feed length ToF to picking sensor [decimillimeter]
23,2
u_a
feed length ToF to peeler [decimillimeter]
23,3
u_a
winder motor start speed [PPS]
23,4
u_a
winder motor final speed [PPS]
23,5
u_a
number of winder motor speedup stages
23,6
e_w
microstep resolution, range 1...8
23,7
e_w
motor current: 0...31
23,9
u_a
run-down time fwd [ms]
23,10
u_a
forward time fwd [ms]
23,11
u_a
forward time bwd [ms]
23,12
u_a
continuation time bwd [ms]
23,13
u_a
winding time fwd [ms]
Module 24
End of Ticket (EoT)
24,1
u_w
output equipment
0: cutting edge / 1: cutter
24,2
u_a
1: enable cuts / 0: disable cuts
24,3
u_a
distance between cuts [2 dot lines]
0: single cut
24,4
u_a
1: partial cut / 0: full cut
24,5
u_a
1: enable feed after cut / 0: disable feed after cut
24,6
u_w
picking timeout [seconds]
0: never wait / 255 wait forever
24,7
u_a
TRUE: 1st cut only on PaperEnd condition
FALSE: inhibit cuts
24,8
u_a
eject length [dot lines]
0: do not eject paper on PaperEnd condition
24,9
u_a
picking sensor
0: NONE, 1: AUX1, 2: AUX2, 3: AUX3, 4: AUX4, 5: AUX5, 6: AUX6, 7: AUX7
24,10
u_a
insertion sensor
0: NONE, 1: AUX1, 2: AUX2, 3: AUX3, 4: AUX4, 5: AUX5, 6: AUX6, 7: AUX7
GeBE Elektronik und
phone
+49.89.894141-0
GeBE-document-no. SoMAN-C32-E-V2.2-0793
Feinwerktechnik GmbH
fax
+49.89.894141-33
date
July 7, 2020
Beethovenstraße 15
page 26 | 166
82110 Germering
Our general terms of business are to be applied.
Germany
Internet
www.gebe.net
Errors and changes reserved.
