GE Vivid in, Service Manual

Page: 467 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-115
7-6-1-3 PC Doctor
NOTE: For a complete description of all PC Doctor tests, refer to the information in PC Doctor on page 7 - 15 .
This procedures in this section are divided into two groups. Refer to the relevant procedure, as follows:
• Automatic Tests
- Full Back End Test w/o Hard Disk Scan - see below
- Full PC Doctor Test (50 min) on page 7 - 117
- CPU Tests on page 7 - 119
- HD Test on page 7 - 122
- Memory Test on page 7 - 124
- Video Test on page 7 - 126
- PCI Test on page 7 - 128
- Network Test on page 7 - 130
7-6-1-3-1 Full Back End Test w/o Hard Disk Scan
NOTE: For a description of this test, refer to Full Back End Test without Hard Disk on page 7 - 15 .
1.) In the Diagnostic Test window, trackball to
Full Back End Test w/o Hard Disk Scan
in the list of PC
Doctor tests available for selection from the Diagnostic Test Tree (see Figure 7-80 below ) and press
Set
. The Test name is displayed under Execute; the relevant system components to be tested are
highlighted light blue in the Schematic View (BEP, Peripherals, Keyboard), as shown below:
2.) Under the Special Instructions area, activate the
Loops
checkbox
and select the required number of Loops from the combo box.
3.) Adjacent to On Fail, select either
Stop
or
Continue
, as required.
Stopping on failure enables you to review a failed test, the moment it fails. Alternatively, you may
prefer testing to continue on failure and later you may review the report.
Figure 7-80 Full Back End Test w/o Hard Disk Scan