GE M60 UR Series, Instruction Manual

Page: 168 / 662

5-40 M60 Motor Protection System GE Multilin
5.2 PRODUCT SETUP 5 SETTINGS
5
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first “Off” value. Since DNP / IEC
60870-5-104 point lists must be in one continuous block, any points assigned after the first “Off” point are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the M60 is restarted.
k) IEC 61850 PROTOCOL
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

IEC 61850 PROTOCOL
The M60 Motor Protection System is provided with optional IEC 61850 communications capability. This
feature is specified as a software option at the time of ordering. See the
Order Codes section in chapter 2
for details.
Use independent ports for IEC 61850 communication and take care when configuring the settings,
else loss of protection or misoperation of the relay can result.
The M60 supports the Manufacturing Message Specification (MMS) protocol as specified by IEC 61850. MMS is supported
over two protocol stacks: TCP/IP over Ethernet. The M60 operates as an IEC 61850 server. The
Remote Inputs and Out-
puts section in this chapter describe the peer-to-peer GSSE/GOOSE message scheme.
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

IEC 61850 PROTOCOL

GSSE/GOOSE CONFIGURATION

IEC 61850 PROTOCOL


GSSE / GOOSE

CONFIGURATION
MESSAGE

SERVER

CONFIGURATION
MESSAGE

IEC 61850 LOGICAL

NODE NAME PREFIXES
MESSAGE

MMXU DEADBANDS

MESSAGE
 GGIO1 STATUS

CONFIGURATION
MESSAGE

GGIO2 CONTROL

CONFIGURATION
MESSAGE
 GGIO4 ANALOG

CONFIGURATION
MESSAGE

GGIO5 UINTEGER

CONFIGURATION
MESSAGE

REPORT CONTROL

CONFIGURATION
MESSAGE

XCBR

CONFIGURATION
MESSAGE

XSWI

CONFIGURATION

GSSE / GOOSE

CONFIGURATION

TRANSMISSION

MESSAGE

RECEPTION

NOTE
NOTE