GE 5205000, Service Manual

Page: 628 / 808

GE
D
IRECTION
5535208-100, R
EV
. 2 LOGIQ E9 S
ERVICE
M
ANUAL
8 - 282 Section 8-11 - Peripherals replacement
8-11-7-4 Printer Tray removal
1.) Raise the console height to the highest level.
2.) Unlatch the two latches ( 1 ) that clamp the Printer Tray to the top of the BEP ( 2 ).
3.) Tilt the Main Console Front Cover forward just until the lower Column Cover stop tabs ( 3 ) clear.
4.) Lift the Column Cover Assembly.
5.) Push the Printer Tray toward the Card Cage approximately 1/2 inch to free the three tabs ( 4 ) from
the BEP.
6.) Remove the Printer Tray from the BEP.
8-11-7-5 Printer Tray installation
1.) Position the Printer Tray at the top of the BEP.
Be sure the lip, on the underside of the bracket, hooks on the edge of the card rack, and the three
tabs insert into the slots on the top of the BEP frame. The lip “clamps” the card rack and BEP
together. This is a tight fit.
2.) Lower the lower Column Cover.
3.) Position the Main Console Front Cover to engage the lower Column Cover stop tabs.
4.) Latch the two latches that clamp the Printer Tray to the top of the BEP.
5.) Slide the Black and White printer into the Printer Tray and connect the cables to the back of the
printer.
6.) Tighten the Printer Tray wing nut to secure the printer.
7.) Connect the printer cables.
8.) Replace the covers.
9.) Perform Functional Checks. See: 8-11-9-3 - Calibration and adjustments ,
8-11-9-4 - Verification and 8-11-9-5 "Functional Checks" on page 8-297 .
Figure 8-70 Printer Tray