Furuno FAR 3220, Installation Manual

Page: 86 / 245

2. WIRING
2-44
7. Fabricate the antenna cable as shown below.
RW-00135
See "How to fabricate the LAN cable" on page 2-36 for how to attach the LAN
cable connector.
RW-9600/6895/4873
8. Pass the antenna cable through the cable clamp.
9. Connect the power line of the antenna cable to the 13-pin WAGO connector, re-
ferring to the interconnection diagram at the back of this manual.
10. Connect the power line and the LAN cable of the antenna cable as shown below.
Sheath Sheath
Armor Vinyl tape
Crimp-on lug (M3)
Braided
shield
LAN cable
6
170
100
40
30
100
Power line
250
Wrap the shield of LAN cable
with vinyl tape.
Crimp-on lug (M4)
Sheath Sheath
Armor
6
170
100
40
30
Crimp-on lug (M4)*
Power line
Coaxial cable
14
5
9
180
Vinyl tape
Shield
(Two shields for RW-4873)
Insert the antenna cable. Insert the antenna cable.
For retrofit antenna
cable, connect unused
lines here.
Connect power line of
antenna cable to TB131
on PSU-TB Board. Connect power line of
antenna cable to TB131
on PSU-TB Board.
Connect LAN cable of
antenna cable to J102
on PSU-CNTL Board.
Ground the LAN
cable.
Clamp the armor.