Furuno FAR 3220, Installation Manual

Page: 50 / 245

2. WIRING
2-8
2. Disconnect the performance monitor connector (J807) and the motor drive con-
nectors (J803, J804 and J808) from the RF-TB Board.
3. Unfasten the six bolts in the figure below to enable removal of the transceiver
unit.Then, pull the handle on the transceiver unit to remove the unit. For magne-
tron radar, lay the unit on its side or on top of non-ferrous material, to pre-
vent demagnetization of the magnetron.
4. Unfasten four screws to open the cable entrance cover.
How to change the orientation
The orientation of the cable entrance can be changed, in one of the three orienta-
tions shown in the following figure.
No other orientation is allowed, to maintain
watertight integrity. The default orientation is "deck". To change the entrance,
unfasten the four screws circled in the following figure, then orient the cable en-
trance in the required direction. Refasten the screws.
REAR REAR REAR
J808 (motor) J808 (motor) J808 (motor)
J804 (motor) J804 (motor) J804 (motor)
J803 (motor) J803 (motor) J803 (motor)
J807 (performance monitor) J807 (performance monitor) J807 (performance monitor)
RF-TB board (03P9570)
Handle Handle
REAR REAR
Magnetron radar
Solid state radar
Handle Handle
Cable entrance cover Cable entrance cover