Furuno FAR 3220, Installation Manual

Page: 112 / 245

2. WIRING
2-70
<Solid state radar>
3. Unfasten two screws to remove the cover plate from the SPU board.
4. Connect the power cable to the converter, pass it through the locking wire saddle
then connect it to J824 on the SPU board. Note polarity before connecting. Close
the cover plate.
5. Connect the LAN cable to the LAN port on the transceiver unit. Pass the cable
through the locking wire saddle then connect it to the LAN port on the converter.
6. Open the BNC case to connect the coaxial cable to the BNC case, then close the
case.
7. Fasten the BNC case to the antenna unit, then mount the transceiver unit.
8. Connect the coaxial cable from the converter to the BNC case, passing through
the locking wire saddle.
Pass the cable through two locking
wire saddles then connect it to the
LAN port on the converter.
Connect the LAN cable to the
LAN port then pass it through
the locking wire saddle.
LAN port LAN port
<Magnetron radar> <Solid state radar>
Fasten conductor
with screw.
Fasten shield
with clamp. Loosen two screws on
the BNC case.
BNC case BNC case
14 5 9
Coaxial cable of the
antenna cable
Fasten the BNC case to
the rail inside the antenna
unit with two screws.
Coaxial cable Coaxial cable Coaxial cable
Connect the coaxial cable to the BNC case,
passing through the locking wire saddle.
<Magnetron radar> <Solid state radar>
Three locking
wire saddles