Furuno FAR 3220, Installation Manual

Page: 54 / 245

2. WIRING
2-12
3) Pass the de-icer power cable through
the cable band. Connect the cable to
TB901 on the DE-ICER board
(03P9573), using the supplied crimp-
on lugs.
4) Attach the motor and connectors re-
moved at step 1).
5) Set the Voltage Setting switch accord-
ing to the power source for the de-icer;
115 V or 230 V. The default setting is
230 V.
6) Apply power to the de-icer then press and hold the TEST switch for about ten
seconds. Check that the heater gets hot and then release the TEST switch.
7) Coat the gasket (all brims) of the intake with the supplied oil compound. Be
sure to coat the gasket completely.
8) Set the front cover to the Antenna Unit. Close the open heater and return it to
its original position.Take care not to hit the heater elements on the chassis or
radiator.
9) Fasten the base of the heater with two M5 screws and apply the adhesive to
the screw heads. Also, fasten the fixing shafts for the cover bolts with two M5
screws.
10. Position the cables so their armors lie beneath their respective cable clamps in the
cable entrance. Fasten the cable clamps.
TB901
Cable band Cable band
Front cover, inside view
Oil compound
Brim Brim
M5 screw M5 screw
Fixing
shaft
Fixing
shaft
Cover bolt Cover bolt
M5 screw M5 screw
Cable clamp