Furuno FAR 3220, Installation Manual

Page: 108 / 245

2. WIRING
2-66
MC-3010A/3020D/3030D
This paragraph shows how to set the MC-ANLG Board (24P0115, for MC-3010A),
MC-DIN Board (24P0116, for MC-3020D) and MC-DOUT Board (24P0117, for MC-
3030D).
Rotary switch : Use the rotary switch (U18) to set the MODBUS address with a digit
of number from "0". When multiple sensor adapters are connected to the MC-3000S,
the same number cannot be used among them. (It is allowed to use the same number
between the MC-3000S and a sensor adapter.)
Jumper block J15 Connector J5 (CH2)
1-2 SHORT Termination resistor: ON (default setting)
2-3 OPEN
1-2 OPEN Termination resistor: OFF
2-3 SHORT
Jumper block J16 Connector J6 (CH3)
1-2 SHORT Termination resistor: ON (default setting)
2-3 OPEN
1-2 OPEN Termination resistor: OFF
2-3 SHORT
Jumper block J17 Connector J7 (CH4)
1-2 SHORT Termination resistor: ON (default setting)
2-3 OPEN
1-2 OPEN Termination resistor: OFF
2-3 SHORT
U18
U18
U18
J25
J25
J25
J3
J4
J5
MC-ANLG Board (24P0115)
MC-DIN Board (24P0116) MC-DOUT Board (24P0117)