Furuno FAR 3220, Installation Manual

Page: 67 / 245

2. WIRING
2-25
Magnetron radar
 Destination of Antenna cable:
Power line : TB801 through the locking wire saddle (A)
LAN cable : J821 through the locking wire saddles (B, two places)
Shield of power line : Screw (C)
Shield of LAN cable : Screw (D)
Note: For the antenna cable RW-9600/6895/4873, connect the crimp-on lug
(that binds unused wires) together with the shield of the power line.
 Destination of sub monitor cable
Note: Remove (or Loosen) four bolts as shown in the following figure to re-
move the RF-TB Board from the RF unit.
Signal line : TB803 through the locking wire saddle (A), see the figure for the
"Destination of Antenna cable:"
Coaxial cable : TB804 (B)
Shield of signal line : Screw (C)
REAR REAR
TB801
(C)
Power line
Connect shield for power line
(A)
REAR REAR
J821
(D)
Connect shiled
for LAN cable
LAN cable
(B)
(B)
REAR REAR
TB804
Fasten shield
with clamp. Fasten conductor
with screw.
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
increasing.
Remove Remove
Loosen Loosen
TB803
(B)
(B)
(C)