Furuno FAR 3220, Installation Manual

Page: 36 / 245

1. INSTALLATION
1-14
How to mount the unit flush with mounting surface
1. Drill four mounting holes of 5 mm diameter referring to the outline drawing at the
back of this manual.
2. Fix the control unit with four screws (M4, local supply) from the underside of the
desktop.
1.4.2 Flush mounting
Use the applicable optional flush mount kit to install the control unit in a console.
Note: For flush mounting in a panel, the mounting surface must be flat. Do not install
the unit on an uneven surface.
Flush mount kit
1. Prepare a cutout in the location referring to the outline drawing at the back of this
manual.
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the hex. nuts as shown in figure below.
Control Unit Type Code
RCU-025 OP24-24 001-171-790
RCU-026 OP24-27 001-171-820
Desk fixing plate
RCU-026 RCU-025
RCU-026
RCU-025
RCU-025 RCU-026