Furuno FAR 3220, Installation Manual

Page: 68 / 245

2. WIRING
2-26
Solid state radar
 Destination of Antenna cable:
Power line : TB801 through the locking wire saddle (A)
LAN cable : J821 through the locking wire saddles (A and B, two places)
Shield of power line : Screw (C)
Shield of LAN cable : Screw (D)
Note: For the antenna cable RW-9600/6895/4873, connect the crimp-on lug
(that binds unused wires) together with the shield of the power line.
 Destination of sub monitor cable
Signal line : TB803 through the locking wire saddle (A), see the figure for the
"Destination of Antenna cable:"
Coaxial cable : TB804 (B)
Shield of signal line : Screw (C)
REAR REAR
TB801
Connect shield
for power line
Power line
(C)
REAR REAR
LAN cable
J821
(D) Connect shield
for LAN cable
(B)
(A)
REAR REAR
RF-TB board (03P9570)
TB803
TB804
Fasten shield
with clamp.
Fasten conductor
with screw.
NOTE: Do not use crimp-on
lug, to prevent contact
resistance from increasing.
(B)
(B)
(C)