Furuno FAR 3220, Installation Manual

Page: 51 / 245

2. WIRING
2-9
5. Unfasten the two screws fixing the cable clamp for antenna cable, then pass the
antenna cable through the cable entrance.
If applicable, unfasten the two screws fixing the cable clamp for the sub monitor
and de-icer power cable, then pass the cables through the cable entrance.
Note: Dummy plugs are provided to insert into unused cable slots for waterproof-
ing.
6. Pass the cables through their respective locking wire saddles in the chassis from
the cable entrance.
Note: Make sure to pass the cable through the specified locking wire saddle.
Mid-stern
entrance
Stern
entrance
Available direction of cable entrance
Deck entrance
(Factory setting)
(Bow direction →)
Remove four screws to change
the direction of cable cover.
Remove two screws to remove the
cable clamp for antenna cable.
Cable entrance Cable entrance
Antenna cable
Remove two screws to remove the cable
clamp for the sub monitor and de-icer power
cable.
De-icer power cable
Sub monitor cable