Furuno FAR 3220, Installation Manual

Page: 58 / 245

2. WIRING
2-16
3. Unfasten four screws to open the cable entrance cover.
Note: The orientation of the cable entrance can be changed. See "How to change
the orientation" on page 2-8.
4. Unfasten the two screws fixing the cable clamp for the serial cable, then pass the
serial cable (TTYCYSLA-10) through the cable entrance.
If applicable, unfasten the two screws fixing the cable clamp for the de-icer power
cable, then pass the cables through the cable entrance.
Note 1: The dummy plug is provided to insert into the unused cable slot. Insert the
plug for waterproofing.
Note 2: The sub monitor cable is connected to the transceiver unit. See
section 2.8.2.
5. Pass the serial cable through the cable entrance and locking wire saddle.
Note: Make sure to pass the cable through the specified locking wire saddle.
Cable entrance cover Cable entrance cover
Remove two screws
to remove the cable
clamp for serial cable.
Cable entrance Cable entrance
Serial cable
Remove two screws to
remove the cable clamp
for de-icer power cable.
De-icer power cable