Furuno FAR 3220, Installation Manual

Page: 78 / 245

2. WIRING
2-36
How to fabricate the LAN cable
Fabricate the LAN cable (FR-FTPC-CY,
DTI-C5E350 VCV), as shown below.
(Wrap both edges of the armor with vi-
nyl tape.) Make sure the shield of the
cable contacts the shell of the modular
plug. For how to attach the modular
plug, see "LAN cable" on page 2-5.
Note : For a locally supplied LAN cable,
expose the armor and clamp the armor
with the cable clamp.
2.6.2 How to connect cables inside the processor unit
How to fabricate the cables
Fabricate the JIS cables (see the Appendix for equiva-
lent cables if not available locally) as shown below.
Connect the cables to the WAGO connectors on the I/O
Board (24P0124) inside the processor unit.
For locations of cables and cores, see the sticker on the
reverse side of the top cover. (All dimensions in millime-
ters)
Wrap vinyl tape. (width: 20 mm)
Cable jacket
Armor
Outer vinyl sheath
Inner vinyl sheath
55 30
Processor unit, cover removed
Crimp-on lugs for
drain wires
Shield
6
5
100
*
30
Armor
Sheath
L
<Fabrication of TTYCS series>
<Fabrication of TTYCSLA series>
Vinyl tape (Width: 20)
After exposing cores, wind shield around the armor.
Clamp here by cable clamp.
“L”
TTYCS-4,
TTYCSLA-4,
TTYCS-1Q,
TTYCSLA-1Q
TTYCS-10,
TTYCSLA-10
400
380
Cable type (JIS)
Pass the heat shrinkable tube (local supply) onto the drain wire,
then attach the crimp-on lug (preattached to the earth clamp on
the processor unit) to it.
Sheath
Armor
Vinyl tape (Width: 20)
Drain wire
Crimp-on lug
30
L
6
Cable tie (supplied)
Clamp here by cable clamp.