background image

Bridge Mate

 RadaScan 

Transponder Guide

Hazardous Area Installations

Special Conditions of Use

Bridge Mate™ RadaScan transponders are classified as intrinsically safe apparatuses and associated apparatuses, and can be used:

· in Zones 1 and 2 with flammable gases and vapors belonging to gas groups IIA/B.  (Reference: EU ATEX directive 94/9/EC,  

Annex II, 1.06)

· in Class I, II and III, Div 1 hazardous (classified) locations.  (Reference: USA UL STD 913)

Instructions for Safe Use

· Bridge Mate™ RadaScan transponders contain no user-serviceable parts.  They can only be serviced by Marine Technologies or other 

approved service representative.

· The front or back panels of the transponder should 

never

 be removed in a hazardous area.

· Transponders are only certified for use in ambient temperatures between -13° F to 131° F (-25° C to 55° C) and should not be used  

outside this temperature range.

· The front cover of the transponder presents a 

static hazard

 and should only be cleaned using a damp cloth.

Bridge Mate

TM

RadaScan

Positioning and Mounting

The location, range and orientation of the transponders in relation to the sensor have a significant effect on the tracking performance  

of the Bridge Mate™ RadaScan system, and hence on the quality of the position data sent to the DP system.
RadaScan is a radar-based system.  Metallic structures reflect the microwave beam transmitted by the sensor, and can cause multipath  

interference, where ghost images are reported by the system.  However, this unwanted phenomenon can be prevented by carefully  

positioning the transponders according to the guidelines on the following page.

Maintenance and Servicing

Bridge Mate™ RadaScan transponders do not contain any user-serviceable parts.  The 

unique transponder ID is programmed at the factory and can only be changed by the 

manufacturer.
The transponder will operate continuously for one year from the date it was switched on.  

The battery replacement date is written on a label affixed to the back of the transponder.

Transponders must be serviced annually

 by Marine Technologies or other approved 

service representative.

Transponder ON/OFF Switch

Switching the Transponder On or Off

Bridge Mate™ RadaScan transponders are always switched on before they are shipped.  If 

the transponder needs to be switched on or off, follow these steps:

1.  Move the transponder to a dry, 

non-hazardous

 area.

2.  Remove the back cover from the transponder.
3.  Move the 

ON/OFF switch

 to the required position.

4.  Replace the back cover, ensuring that the seal is good.

Note:  The front or back panels of the transponder 

should never be removed in a hazardous or wet area.

Reviews: