Fujitsu ScanSnap iScanner fi-6010N, Operator'S Manual

Page: 211 / 665

4.10 Using the Maintenance Menus
fi-6010N Network Scanner Operator's Guide 173
4
■
Restoring System Settings
The system settings backup file can be returned to the scanner to restore system settings to those at
the time backup was taken.
1. Select the [Maintenance] tab on the top menu.
2. Select the [System Settings File] tab on the left side menu.
The "System Settings File" screen appears.
3. Enter a backup file to restore from.
Press the [Browse] button to select a file.
4. Press the [Restore] button.
A confirmation message appears.
5. Press the [Yes] button.
After factory default settings have been restored, the scanner is restarted.
ATTENTION
Do not change the contents of system settings backup files.
If changed, the file may no longer be used as a backup. Trying to
restore from a changed system settings backup file may render the
scanner inoperable.
ATTENTION
During system settings restoration, do not press and hold down the
startup button for longer than 4 seconds, as it may cause the scanner
to function abnormally.
HINT
The network interface connection will be lost when the scanner is restarted
to complete the restoration of the system settings. To continue with other
settings, wait a short time for the device to restart, then login to the net-
work interface again.
As the network interface connection to the scanner requires the IP
address or scanner name, if this is changed by the restoration of the sys-
tem settings (i.e. if the backed up IP address or scanner name is different
to the pre-restoration IP address or scanner name), the new IP address or
scanner name will be needed. If not known, the current state of these set-
tings can always be checked by physically logging in to the scanner via the
touch panel interface.