FujiFilm ED-580XT, Operation Manual

Page: 74 / 136

897N200877B
4-22
Chapter 4 Preparation and Inspection
4.6 Connecting Endoscope to Light Source, Processor and
Related Equipment
This section explains how to connect the endoscope to the light source, processor and related
equipment.
4.6.1 Connecting to Light Source
WARNING
• Firmly connect the LG connector of the endoscope and the light source as well as the
video connector and the processor. If the LG connector is not connected properly, the
endoscopic image may flicker or be lost, which may cause patient injury, bleeding and/or
perforation.
CAUTION
• Firmly connect the LG connector of the endoscope and the light source. Do not look into
the connecting part between the endoscope and the light source. Light leaking from the
connecting part may cause damage to the eyes.
• Immediately after detaching the LG connector from the light source, do not touch the light
guide prong with hands since it may be extremely hot. There is a risk of burn injury.
(1) Make sure that the light source, processor and related equipment are turned off.
Note The endoscope can be connected or disconnected when the EXAM. indicator lamp on
the processor is set to “STANDBY.” For details, refer to the operation manual of the
processor.
(2) Make sure that no moisture or foreign matter (such as dust, gauze fibers, metallic fragments)
adheres to the light guide prong of the LG connector.
Scope Socket
LG Connector
(3) Insert the LG connector straight into the scope socket of the light source until it stops.
(4) Visually check that the LG connector is fully inserted.
ED580XT_E2-30_897N200877B.indb 22 2018/09/20 15:50:22