897N200877B
4-6
Chapter 4 Preparation and Inspection
4.3 Inspecting Endoscope
Prior to inspection, make sure that dirt does not adhere to the endoscope. If dirt adheres to the
endoscope, reprocess it according to the instructions given in the Reprocessing Manual.
4.3.1 Inspecting Control Portion
(1)
Visually and manually inspect the control portion for excessive scratches, deformation, cracks,
residue, loose parts, or other irregularities.
4.3.2 Inspecting Insertion Portion
CAUTION
• Do not forcibly twist or bend the insertion tube of the endoscope. It could damage the
endoscope.
(1)
Visually inspect the boot and the insertion portion near the boot for bends, twists, swelling or
other irregularities.
(4)
(2)
(2)
Visually and manually check the insertion portion (distal end, bending section and insertion
tube) for abnormalities such as indentations, bumps, peeling, sharp edges or protrusions, etc.
In addition, confirm that the insertion tube is not abnormally rigid.
(3)
Visually and manually check the bending section sheath and adhesives at each end of the
bending section for abnormalities such as missing epoxy, roughness, pitting or flaking.
ED580XT_E2-30_897N200877B.indb 6
2018/09/20 15:50:20
Summary of Contents for ED-580XT
