Fuji Xerox ApeosPort-V 6080, Administrator'S Manual

Page: 58 / 745

2 Paper and Other Media
58
P
a
p
e
r an
d Oth
e
r M
e
dia
2
11
Specify the type of the paper loaded when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.60).
Changing the Paper Size for Trays 6 and 7 (HCF (A4 2 Tray)) (Optional)
The following describes the procedure for changing the paper size for Tray 6 and 7 (HCF (A4
2 Tray)) (optional).
Note • When changing the paper size to non-standard size loaded in Trays 6 and 7, contact our Customer
support Center. If doing so, it never returns to the original setting.
1
Pull out the tray until it stops.
Important • While the machine is processing a job, do not
pull out the tray that the job uses.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the tray,
and then load the new stack of paper.
2
Remove any paper loaded in the tray.
3
Loosen the screws (1), and remove the guides
from the front and back of the tray (2).
4
Attach the guides according to the hole of the
paper size to change (1), and tighten the
screws (2).
5
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
6
Push the tray in gently until it stops.