![background image](http://html1.mh-extra.com/html/freecom/quantum-superloader-3/quantum-superloader-3_manual_2329731065.webp)
Chapter 4 On-board Remote Management
Configuration Page
SuperLoader 3 Autoloader User’s Guide
47
2
Scroll to
Cleaning Tape
.
If a check mark appears in the box next to
Auto Clean
, the option is
enabled. To disable
Auto Clean
, click the box to remove the check
mark. If no check mark appears in the box next to
Auto Clean
, the
option is disabled. To enable
Auto Clean
, click the box to enter a check
mark.
3
In the
Cleaning Tape Location
field, select the appropriate slot location
where you installed the cleaning tape. If
Auto Clean
is disabled,
cleaning is managed by the backup package you have installed
instead.
4
Click
submit
.
Setting the Magazines
4
This setting is used to report the number of storage elements and the
element address to the SCSI host. This setting must match the physical
configuration in order for correct information to be reported. This setting
only affects the information reported to the SCSI host. This setting does
not affect the access to magazine slots from the front panel or On-board
Remote Management. Those interfaces are based on the physical
configuration.
When configured for
Both
magazines, the autoloader always reports 16
storage elements to the SCSI host. This allows the removal and
reinstallation of magazines without affecting what is reported to the host.
When configured for
Left
or
Right
, the autoloader will always report eight
storage elements to the SCSI host.
The element addresses vary depending on which magazine is configured.
If
Left
or
Right
is selected, and both magazines are physically installed,
the front panel and On-board Remote Management allow the user access
to the other magazine, but the SCSI host will not have access.
To set the
Magazines
option:
1
From any page, click the
Configuration
heading. The
Configuration
screen displays.
2
Scroll to
Magazines
. The
Magazines
options display.
A check mark appears after the currently enabled mode.
3
Do one of the following:
• To leave the
Magazines
mode unchanged, press
Esc
.
Summary of Contents for Quantum SuperLoader 3
