Chapter 7 Customer Replaceable Units (CRUs)
Rack Mounting the Autoloader
92
SuperLoader 3 Autoloader User’s Guide
4
Using rack screws, attach a support bracket to the clip nuts on each
rear rail (see
figure 14
.)
Tighten the screws just enough to hold the support brackets firmly
against the rail while still allowing the support bracket to be slightly
shifted by hand. This shifting will help facilitate the engagement of
autoloader brackets as the autoloader is installed in the rack. You will
fully tighten the screws in
step 8
.
Figure 14 Attaching
Support Brackets
Note:
Be sure to attach the support brackets correctly; the side of
the bracket with only two holes should be secured to the
rail.
Outer cover of rack
Rear rail in rack
Support bracket
Clip nuts
Rack
screws
Summary of Contents for Quantum SuperLoader 3
