Freecom Quantum SuperLoader 3, Manual, Page: 88 / 230

Chapter 5 Administration
Setting the Change Mode
70 SuperLoader 3 Autoloader User’s Guide
3 From the
Sequential Ops
menu, scroll to
Stop
, and then press
Enter
.
Ejecting tape from drive
appears on the LCD.
To resume
Sequential
mode operation:
1 From the main menu, scroll to
Commands
, and then press
Enter
.
2
From the
Commands
menu, scroll to
Sequential Ops
, and then press
Enter
.
3
From the
Sequential Ops
menu, scroll to
Resume
, and then press
Enter
.
Moving next tape to drive
appears on the LCD.
Setting Security 5 You can add security to the front panel by password-protecting the
autoloader's functionality. The security setting only protects the front
panel functionality. The default setting is
Off
, meaning that no password
is required. However, you can enable the security option so that users
must enter a password to access functionality.
Security Option 5
When you first power on the autoloader, the security option is set to
Off
.
Use the following procedure to enable the security option. You must have
an administrator-level password to set passwords.
To set the security option:
1 From the main menu, scroll to
Configuration
, and then press
Enter
.
2 From the
Configuration
menu, scroll to
Security
. If a check mark
appears after the word, the security option is
On
. If no check mark
appears, the security option is
Off
.
3
To change the option, press
Enter
. For example, if the security option
was set to
On
, it is now set to
Off
, and no check mark appears.
Setting Magazines 5 In some cases, autoloader owners were being charged Independent
Software Vendor (ISV) licensing fees for two-magazine SuperLoader 3s
although only one magazine was configured. This occurred because the
ISV software was registering the autoloader as a two-magazine device,
regardless of the number of magazines configured. You have the ability
to set the number of magazines in the autoloader.