![background image](http://html1.mh-extra.com/html/freecom/quantum-superloader-3/quantum-superloader-3_manual_2329731078.webp)
Chapter 5 Administration
Configuring the Autoloader
60
SuperLoader 3 Autoloader User’s Guide
When you first power on the Quantum SuperLoader 3 autoloader, it
automatically runs a Power-On Self-Test (POST). During the POST, the
left (green) LED flashes. After the POST, the left (green) and right (amber)
LED flash alternately back and forth. Do one of the following:
• If the autoloader powers on successfully, continue configuring the
autoloader (see
Configuring the Autoloader
).
• If the autoloader does not power on successfully, check the following:
• Power switch is on.
• Power cable is inserted correctly.
• SCSI bus is terminated.
• SCSI cable is connected to the autoloader and host computer.
• No error code appears on the autoloader LCD.
• If you cannot resolve the problem yourself, contact your service
representative or go to
www.quantum.com
.
When you first power on the autoloader, the setting for the Internet
Protocol (IP) address is static with the address
192.168.20.128
. If you want
to use Dynamic Host Configuration Protocol (DHCP) to change the IP
address, see
Setting the IP Address
on page 63. To determine the IP
address when using DHCP, view the Ethernet status information (see
Setting the SCSI ID
on page 62).
Configuring the Autoloader
5
To configure the autoloader, start with the main menu on the front panel.
If the main menu is not already visible on the LCD, press
Enter
.
Note:
The front panel requires a six-digit password to change the
configuration (see
Setting Passwords
on page 71). The
LCD front panel default password for the Administrator is
000000
. The default password for the Operator is
111111
.
Summary of Contents for Quantum SuperLoader 3
