Freecom Quantum SuperLoader 3, Manual, Page: 64 / 230

Chapter 4 On-board Remote Management
Configuration Page
46 SuperLoader 3 Autoloader User’s Guide
Compression 4
For the Quantum SuperLoader 3 autoloader, data compression is drive-
dependent. The front panel and On-board Remote Management will
display whether or not compression is enabled.
Compressing the data means that the drive can write more data to the
same amount of tape. Compression also increases the performance of the
data transfers from or to the SCSI bus.
To view the compression setting:
From any page, click the
Configuration
heading. The
Configuration
screen
displays. Under the
Compression
heading, the current compression
setting is displayed as
Compression Enabled
or
Compression Disabled
.
Cleaning Tape 4
To enable or disable the
Auto Clean
function, you must also designate a
full slot for the cleaning tape cartridge. If a slot has not been designated,
the box displays
None
. To designate the cleaning tape slot:
1 Load a cleaning tape into an empty slot using the
Commands
page.
2
Enable or disable
Auto Clean
by selecting the check box.
To set
Auto Clean
:
1
From any page, click the
Configuration
heading. The
Configuration
screen displays.
Note: Compression cannot be changed from the front panel or On-
board Remote Management of the autoloader.
Note: If
Auto Clean
is disabled, the cleaning tape will
automatically be ejected via the mailslot. Cleaning is
managed by the backup package you have installed
instead.