203
24-2-4. Sending Tally Signals to Tally Units
Up to three tally units can be connected. This section explains how to set up TALLY1 (the tally
unit 1) as an example.
Selecting Tally Color for an Output Bus
See section 24-2-1 "Tally Color Settings." The Tally Color settings made in this menu are
shared with those for the GPI/TALLY OUT connectors, TALLY OUT connector (HVS-30TALR)
and the Tally Units.
Setting Pin Assignments for TALLY1
(1) Press the page up or down button to return to the [SETUP - GPI/TLY] menu.
(2) Open the [SETUP - GPI/TLY - TALLY1] menu.
SETUP :>TLY COL >GPI IN >GPI OUT>OU GPI/O
GPI/TLY :>
TALLY1
>TALLY2 >TALLY3 >30TALR
(3) Turn F2 to select the pin number under
P NO
.
(4) Turn F3 to select a tally to be assigned under
FUNCTION
. See the table "GPI/TALLY
(5) Set other pin assignments in the same way.
(6) Turn F1 to set ON. This activates all tallies in TALLY1.
GPI/TLY :ENABLE: P NO : FUNCTION : 1/1
TALLY1 : =
ON
: =
1-01
: =
Out:RED TALLY-IN01
The setting procedure for other tally units is the same as for TALLY1. See the
HVS-TALOC/TALR 20/32 operation manual for details about tally connection and operation.
Connection Settings with Tally Units (RS-422 port setting)
Up to three tally units are connected in series to the switcher via RS-422 connector. The
connection settings with Tally Units are made in the menu as shown below.
(1) Open the [SETUP - SYSTEM - RS-422] menu.
(2) Turn F1 to select PORT2.
(3) Turn F2 to select TALLY. Set the parity to EVEN. The baud rate is automatically set
according to the tally unit.
SYSTEM :SELECT :FUNC :BAUDRAT:PARITY : 1/1
RS-422 : =
PORT2
: =
TALLY
: =38400: =
EVEN
:
(4) Restart HVS-390HS. (See section 23-1. "Rebooting System.")
