169
19-3. Saving Data to USB Flash Memory
This section explains how to save panel settings to USB memory by using a "data.all" file as an
example.
(1) Insert a USB flash memory into the USB port.
(2) Press MENU in the CONTROL block, then press FILE to open the FILE top menu.
(3) Turn F1 to select SAVE, and then press F1 or the page down button to open the [FILE -
SAVE] menu.
FILE :>LOAD >
SAVE
>UPDATE
TOP :
(4) Turn F1 to select ALL to the
EXT
(File Extension) item.
(5) Turn F3 to select data. (See section 19-5 "Moving between Directories in the USB Flash
Memory.") Press F3 to save the data to the USB memory.
FILE : EXT : CTRL : DATA.ALL : 1/1
SAVE : =
ALL
: =SAVE : : 101MB
(6) When the data is sent to the flash memory, the message "SAVE?" will appear. Press F3
again to store the data to the flash memory. A "beep" sound will be heard when the data is
saved.
If the same file exists in the USB flash memory:
A pop up window appears and asks if you would like to overwrite the existing file. Turn F3 to
select CANCEL, OVERWR(overwrite) or RENAME.
To Rename the File:
If you wish to rename the file to save it, turn F3 to select RENAME and refer to section 19-7.
"Renaming Files in the USB Flash Memory" to give a new name to the file.
IMPORTANT
When pressing a control push-button, press it down lightly and release it within 1 sec.
Note that if you press and hold a control button down for more than 1 sec., the related
operation will be cancelled. Do not remove the USB flash memory while the access
lamp is flashing. This could corrupt the stored data or damage the USB flash memory.
The time is also recorded when data is saved to a USB flash memory according to the
switcher internal clock. Set the date and time if it is not properly set. (See section 21-7.
"Setting Date and Time.")
