I
Close the front cover, and then move the left and
right lock levers inward.
J
Set the media information on the screen, and
press
OK
.
Do the following settings here.
❏
Media: Set the media to use for printing
❏
Roll Winding Direction: How to wind the
loaded media
❏
Media Length: Length of the loaded media
❏
Media Detection: How to detect the width of
the media
When you select Media Settings while no Media
Type is set in
Media
, the screen to select Media
Type appears. Select the Media Type using the
paper weight of the loaded media as a guideline as
shown below. The paper weights of each Media
Type shown in the screen are typical values.
Media Type
Paperweight (g/m
2
)
Ultra-Thin
39 or under
Thin
40 to 56
Med-Thick
57 to 89
Thick
90 or over
In
Media Detection
, set
Width Detection
.
Normally, leave this
On
.
See the following for details about Media
Detection.
U
“General Settings menu” on page 152
Press
OK
, to start operations, such as detecting
the loaded media.
Printed side out
A
Confirm that the front cover is open.
B
Raise the media loading lever.
C
While pulling the center section of the media
straight down, affix the media to the take up roll
core with commercially available adhesive tape.
c
Important:
Affix the media to the take-up roll core with the
media pulled tightly. If media is affixed loosely,
the media may move around during take-up.
D
Repeat the following procedure and take-up the
media for a double wrap around the roll core.
a. Hold the
button pressed to slightly slacken
the media at the back side.
SC-F10000H Series/SC-F10000 Series User's Guide
Basic Operations
85
