U
“Using the Auto Take-up Reel Unit” on
S
Move to the back side, tap lightly on both edges of
the media, and check if there is a difference in
tension between the left and right sides.
If there is a difference in tension, the media
becomes loose.
From the front of the printer, raise the media
loading lever, and correct the looseness in the
media.
Once the looseness is corrected, lower the media
loading lever.
T
Move to the front side, and while holding the tabs
of the media edge plate on both sides, move the
plate to the top edge of the media.
Adjust so that the edges of the media are aligned
with the center of the triangular holes in the
media edge plates.
The media edge plates prevent the media from
riding up and keep fibers on the cut edge of the
media from touching the print head. Load
correctly.
c
Important:
❏
Do not use the media edge plates with
media that is 0.4 mm (0.01 in.) or more
thick. The media edge plates could touch
and damage the print head.
❏
Always position the plates so that the edges
of the media are at the centers of the
triangular holes. Incorrect positioning
causes banding (horizontal banding, tint
unevenness, or stripes) during printing.
❏
Move the media edge plates to the left and
right edges of the platen when they are not
in use.
❏
Do not use the media edge plates if the
sides of the printed media are smudged.
SC-F10000H Series/SC-F10000 Series User's Guide
Basic Operations
75
