Messages
What to do
The media is not loaded correctly.
Raise the media loading lever and remove
the media. Then reload the media.
Media was not correctly loaded when it was loaded. Refer to the following, and
load the media correctly.
U
There is a problem with the media or the
print results; auto adjust cannot be done.
Adjust manually.
The scanning device may be
malfunctioning.
Contact Epson Support.
Manual adjustment is possible.
Pressing
OK
cancels the error.
When doing Auto execution of Print Adjustments, execution is not possible for the
following media, settings, and environment.
❏
Media with an uneven surface
❏
Media that bleeds-through easily
❏
The printer is used in a place that is exposed to direct sunlight or interference
from other ambient light sources.
In these cases, execute the manual menu.
U
“Print Adjustments” on page 93
If the printer is exposed to interference from ambient light sources, shade the
printer from these sources and perform the function again; it may succeed. When
the function has failed after shading the printer, execute the manual menu.
If the above items do not apply, and the same error occurs again, contact your local
dealer or Epson service call center.
[XXXXX] is different from the winding
direction of the loaded roll media.
Set it to match the winding direction of the
loaded roll media.
Shows the winding specifications that were set in XXXXX when loading media.
Does the
Roll Winding Direction
set when loading media match the actual
winding specifications?
Raise the media loading lever to resolve the error. Lower the media loading lever
again, and follow the on-screen instructions of the printer to reset the
Roll
Winding Direction
correctly.
Cleaning the Anti-Drying Caps.
The anti-drying caps are dirty and need to be cleaned. Follow the on-screen
instructions to check and clean the caps that need cleaning.
U
“Cleaning anti-drying caps” on page 112
Failed to inspect the condition of nozzles.
Cannot run "Auto Cleaning".
Select cleaning strength manually and run
Print Head Cleaning.
The printer has exceeded the temperature at which printer operations are
guaranteed. Adjust the temperature of the room, to start using the printer again.
U
“Specifications Table” on page 213
When an Error Message is Displayed
Error messages
What to do
Parts Service Life Ending XXXXXXXX
One of the parts in the printer is nearing
the end of its service life.
Note the code and call for service.
End Of Parts Service Life XXXXXXXX
Note the code and call for service.
This message notifies you that it is time to replace replacement parts on the
printer.
Contact your dealer or Epson Support and tell them the maintenance request
code.
SC-F10000H Series/SC-F10000 Series User's Guide
Problem Solver
171