Setting Information Printing at
Media Cut
Setting
Information Printing at Media Cut
in advance
is useful because information that is helpful when
managing media is printed whenever media is cut.
For example, when
Paper Remaining Information
is
turned
On
, the length of media that is remaining is
printed. By printing the remaining amount on the
media being removed, you can check this value the next
time the media is loaded and enter the media length.
This is useful for accurate management of the amount of
media remaining.
See the following for details about Information Printing
at Media Cut.
U
“General Settings menu” on page 152
Cutting Media
Caution:
❏
The dryer may be hot; observe all necessary
precautions. Failure to observe the necessary
precautions could result in burns.
❏
Do not put your hand inside the dryer. Failure
to observe the necessary precautions could
result in burns.
❏
When cutting media, be careful not to cut your
fingers or hands with the cutter or other blades.
A
On the control panel screen, press the
and
then
Forward
.
If you want to adjust the cut position, change the
value of the position.
B
Turn Off the Auto switch of the Auto Take-up
Reel Unit.
C
Cut the media at the bottom of the media guide
bar using scissors.
When information, such as the remaining
amount of media, is printed, a line is printed at
the cut position. Print Information is printed on
the printed side of the cut position, and Paper
Remaining Information is printed on the unused
side, so cut along that line.
c
Important:
When you cut the media, check that it does not
rise up inside the front cover or has not come
free from the media edge plate before printing.
SC-F10000H Series/SC-F10000 Series User's Guide
Basic Operations
88
