Epson S5U1C17001C, Manual

Page: 527 / 742

S5U1C17001C ManUal
EPSOn
10-77
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
10 DEBUggEr
10.7.5 Program Execution Commands
continue
(execute continuously) [ICD Mini / SIM]
Operation
Executes the target program from the current PC address.
The program is run continuously until it is made to break by one of the following causes:
• Already set break conditions are met.
• The [Stop] button is clicked.
When reexecuting a target program halted because break conditions have been met, you can specify to disable
the current breakpoint the specified number of times.
Format
continue [
IgnoreCount
]
cont [
IgnoreCount
] (abbreviated form)
IgnoreCount : Specifies the number of breaks (decimal or hexadecimal)
The program is run continuously until break conditions are met the specified number of times.
Usage example
n
Example 1
(gdb) continue
Continuing.
Breakpoint 1, main () at main.c:13
When
continue
is executed with
IgnoreCount
omitted, the target program starts running from the current PC
address and stops the first time break conditions are met.
n
Example 2
(gdb) cont 5
Will ignore next 4 crossings of breakpoint 1. Continuing.
Breakpoint 1, main () at main.c:13
Because value 5 is specified for IgnoreCount , break conditions that have been met four times (= 5 - 1) since the
program started running are ignored, and the program breaks when break conditions are met the fifth time. In
this example, the target program is restarted after being halted at the PC breakpoint (break 1) set at line 13 in
main.c
, and the program stops upon the fifth hit at that PC breakpoint.
The same effect is obtained by executing the following command:
(gdb) ignore 1 4
Will ignore next 4 crossings of breakpoint 1.
(gdb) continue
GUI
In addition to the above, the
continue
command can be executed using one of the following methods. In
such case, however, you cannot specify IgnoreCount .
• Click the [Continue] button in the [Source] window.
[Continue] button
• Choose [Continue] from the [Control] menu in the [Source] window.
• Enter [c] ([C]) while the [Source] window is open.
When the target program is executed by the
continue
command, the contents displayed in the [Source] and
[Registers] windows are updated in real time. The [Memory] window is not updated.
10
Debugger