Epson S5U1C17001C, Manual

Page: 291 / 742

S5U1C17001C ManUal
EPSOn
5-169
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
5 gnU17 iDE
5
IDE
[Create a simple startup command]
[Debugger:]
Select the debugger (connect mode) to connect to.
ICD Mini
When using an ICD to debug.
When [ICD Mini] is selected and [Overwrite] is pressed, the flash load command will also be ex-
ecuted in accordance with the target CPU selected in the [Properties] > [GNU17 General] page.
Simulator
To debug with a PC only.
[Boot vector address] (effective only in simulator mode)
Enter the boot vector address in hexadecimal notation (omit 0x) in the text box when creating a command file
for simulator mode. The address may be specified in 256-byte increments. The
IDE generates a command file
for simulator mode that includes a command for setting this value to the boot vector address. The value ap-
peared here by default is the address that was specified when the project was created.
[Ports]
Selecting ICD Mini or Simulator in [Debugger:] sets the port to USB or NONE, respectively. So no settings are
required.
[Overwrite]
Applies the above settings to the command file shown in the [GNU17 GDB Commands] page and closes the
dialog box. A dialog box appears prompting overwrite, so execution may be canceled even after the button is
clicked.
[Close]
Close the dialog box. The command file shown in the [GNU17 GDB Commands] page does not reflect the con-
tents changed in the dialog box.
If the memory model is changed in the [Properties] > [GNU17 General] page, this dialog box also reverts to the de-
fault setting (ICD Mini).