Epson 6200L - EPL B/W Laser Printer, Reference Manual

Page: 276 / 513

Using the Remote Control Panel Utility (EPL-6200 only)
259
7
7
7
7
7
7
7
7
7
7
7
7
Standby
Allows you to set the Standby mode to Enable (default) or
Disable . When Standby is enabled, the printer goes into sleep
mode if it is not used for 15 minutes. The printer begins warming
up as soon as you send data, and is ready to print in about 16
seconds. When Standby is disabled, the printer stays warmed up
and ready to print all the time.
Timeout
Allows you to set the length of time the printer waits before
looking for the next print job. If the printer is online and receives
no new data for the number of seconds specified, the printer
automatically switches to the next channel that receives data. You
can set the timeout value in 1-second increments (the parameters
are from 5 to 300).
Paper Size Ignore
Allows you to select whether a paper size error is ignored when
it occurs. Turning this item on causes the printer to print even if
the image size exceeds the printable area for the specified paper
size. This may cause smudges, due to toner that is not transferred
onto the paper properly. When this item is
Off (default), the
printer stops printing if a paper size error occurs.
Country (ESCP2, FX only)
Allows you to select the international character set.
CG Table (ESCP2, FX only)
Allows you to select the character table. Character tables contain
the characters and symbols used in different languages. The
printer prints the text based on the selected character table.