Edge-Core AS5700-54X, Cli Reference Manual, Page: 881 / 1116

Chapter 29
| IP Routing Commands
Open Shortest Path First (OSPFv3)
– 881 –
General Guidelines
Follow these basic steps to configure OSPFv3:
1.
Assign an IPv6 link-local address to each VLAN interface that will participate in
an OSPF routing process. You can automatically generate a link-local address
using the
ipv6 enable command, or manually assign an address to an interface
using the ipv6 address link-local command.
2.
Use the router ipv6 ospf command to create a local OSPF router process and
enter router configuration mode.
3.
Use the router-id command to assign a unique identifier to the router. Note that
the default router ID of “0.0.0.0” cannot be used with the current software
version.
4.
Use the ipv6 router ospf area command or the ipv6 router ospf tag area
command to assign an area to each interface that will participate in the
specified OSPF process.
ipv6 ospf
retransmit-interval Specifies the time between resending a link-state
advertisement IC
ipv6 ospf transmit-delay Estimates time to send a link-state update packet over an
interface IC
passive-interface Suppresses OSPF routing traffic on the specified interface RC
Display Information
show ipv6 ospf Displays general information about the routing processes PE
show ipv6 ospf database Shows information about different LSAs in the database PE
show ipv6 ospf interface Displays interface information PE
show ipv6 ospf neighbor Displays neighbor information PE
show ipv6 ospf route Displays the OSPF routing table PE
show ipv6 ospf virtual-links Displays parameters and the adjacency state of virtual links PE
Table 179: Open Shortest Path First Commands (Version 3)
(Continued)
Command Function Mode