Edge-Core AS5700-54X, Cli Reference Manual, Page: 1006 / 1116

Chapter 29
| IP Routing Commands
Policy-based Routing for BGP
– 1006 –
Console(config-route-map)#set community 20:01
Console(config-route-map)#
Related Commands
set comm-list delete (1004)
set extcommunity
This command sets the extended community attributes of routing messages. Use
the
no form to remove this entry from a route map.
Syntax
set extcommunity { rt extended - community-value |
soo extended - community-value }
no set extcommunity [ rt | soo ]
rt – The route target extended community attribute.
soo – The site of origin extended community attribute.
extended - community-value – The route target or site of origin in one of the
following formats:
AAAA : NN or AA : NNNN – Community-number to deny or permit. The
community number can either be formatted as a 4-byte autonomous
system number and a 2-byte network number, or as a 2-byte
autonomous system number and a 4-byte network number, separated
by one colon. Each 2-byte number can range from 0 to 65535, and 4-
byte numbers from 0 to 4294967295.
IP : NN – Community to deny or permit. The community number is
composed of a 4-byte IP address (representing the autonomous system
number) and a 2-byte network number, separated by one colon. The 2-
byte network number can range from 0 to 65535.
One or more community numbers can be entered, separated by a
space. Up to 3 community numbers are supported.
Command Mode
Route Map
Command Usage
◆
Using the rt keyword to specify new route targets replaces existing route
targets.
◆
The route target (RT) attribute is used to identify sites that may receive routes
tagged with a specific route target. Using this attribute allows that route to be
placed in per-site forwarding tables used for routing traffic received from the
corresponding sites.
◆
The site of origin (SOO) attribute is used to identify the site from which the
provider edge (PE) router learned the route. All routes learned from a particular