Edge-Core AS5700-54X, Cli Reference Manual, Page: 181 / 1116

– 181 –
5
SNMP Commands
SNMP commands control access to this switch from management stations using
the Simple Network Management Protocol (SNMP), as well as the error types sent
to trap managers.
SNMP Version 3 also provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific areas
of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups
with the required security model (i.e., SNMP v1, v2c or v3) and security level (i.e.,
authentication and privacy), and then assign SNMP users to these groups, along
with their specific authentication and privacy passwords.
Table 29: SNMP Commands
Command Function Mode
General SNMP Commands
snmp-server Enables the SNMP agent GC
snmp-server community Sets up the community access string to permit access to
SNMP commands GC
snmp-server contact Sets the system contact string GC
snmp-server location Sets the system location string GC
show snmp Displays the status of SNMP communications NE, PE
SNMP Target Host Commands
snmp-server enable traps Enables the device to send SNMP traps (i.e., SNMP
notifications) GC
snmp-server host Specifies the recipient of an SNMP notification operation GC
snmp-server
enable port-traps
mac-notification Enables the device to send SNMP traps (i.e., SNMP
notifications) when a dynamic MAC address is added or
removed IC
show snmp-server enable
port-traps Shows if SNMP traps are enabled or disabled for the
specified interfaces PE
SNMPv3 Commands
snmp-server engine-id Sets the SNMP engine ID GC
snmp-server group Adds an SNMP group, mapping users to views GC
snmp-server user Adds a user to an SNMP group GC
snmp-server view Adds an SNMP view GC
show snmp engine-id Shows the SNMP engine ID PE
show snmp group Shows the SNMP groups PE