Edge-Core AS5700-54X, Cli Reference Manual, Page: 1030 / 1116

Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
– 1030 –
ip pim
trigger-hello-delay
This command configures the maximum time before transmitting a triggered PIM
Hello message after the router is rebooted or PIM is enabled on an interface. Use
the
no form to restore the default value.
Syntax
ip pim trigger-hello-delay seconds
no ip pim trigger-hello-delay
seconds - The maximum time before sending a triggered PIM Hello
message. (Range: 0-5 seconds)
Default Setting
5 seconds
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
When a router first starts or PIM is enabled on an interface, the hello delay is set
to random value between 0 and the trigger-hello-delay. This prevents
synchronization of Hello messages on multi-access links if multiple routers are
powered on simultaneously.
◆
Also, if a Hello message is received from a new neighbor, the receiving router
will send its own Hello message after a random delay between 0 and the
trigger-hello-delay.
Example
Console(config-if)#ip pim trigger-hello-delay 3
Console(config-if)#
show ip pim interface
This command displays information about interfaces configured for PIM.
Syntax
show ip pim interface [ vlan vlan-id ]
vlan-id - VLAN ID (Range: 1-4094)
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command displays the PIM settings for the specified interface as described in
the preceding pages. It also shows the address of the designated PIM router and
the number of neighboring PIM routers.