Edge-Core AS5700-54X, Cli Reference Manual, Page: 456 / 1116

Chapter 17
| Spanning Tree Commands
– 456 –
◆
BPDU guard can only be configured on an interface if the edge port attribute is
not disabled (that is, if edge port is set to enabled or auto with the
spanning-
tree edge-port command).
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#spanning-tree bpdu-guard
Console(config-if)#
Related Commands
spanning-tree edge-port (457)
spanning-tree spanning-disabled (462)
spanning-tree cost
This command configures the spanning tree path cost for the specified interface.
Use the
no form to restore the default auto-configuration mode.
Syntax
spanning-tree cost cost
no spanning-tree cost
cost - The path cost for the port. (Range: 0 for auto-configuration, 1-65535
for short path cost method 7 , 1-200,000,000 for long path cost method)
Default Setting
By default, the system automatically detects the speed and duplex mode used on
each port, and configures the path cost according to the values shown below. Path
cost “0” is used to indicate auto-configuration mode. When the short path cost
method is selected and the default path cost recommended by the IEEE 8021w
standard exceeds 65,535, the default is set to 65,535.
Table 88: Recommended STA Path Cost Range
Port Type Short Path Cost
(IEEE 802.1D-1998) Long Path Cost
(IEEE 802.1D-2004)
Ethernet 50-600 200,000-20,000,000
Fast Ethernet 10-60 20,000-2,000,000
Gigabit Ethernet 3-10 2,000-200,000
10G Ethernet 1-5 200-20,000
40G Ethernet 1-65535 1
1. Undefined in standard.
20-2,000
1
7. Use the spanning-tree pathcost method command to set the path cost method. The range
displayed in the CLI prompt message shows the maximum value for path cost. However,
note that the switch still enforces the rules for path cost based on the specified path cost
method (long or short).