Edge-Core AS5700-54X, Cli Reference Manual, Page: 360 / 1116

Chapter 10
| Interface Commands
Interface Configuration
– 360 –
Interface Configuration
interface
This command configures an interface type and enters interface configuration
mode. Use the
no form with a trunk to remove an inactive interface.
Syntax
[ no ] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a consecutive
list of ports or a comma between non-consecutive ports.
craft - Management port on the front panel.
ethernet unit / port-list
unit - Unit identifier. (Range: 1)
port-list - Physical port number or list of port numbers. Separate
nonconsecutive port numbers with a comma and no spaces; or use
a hyphen to designate a range of port numbers. (Range: 1-32/54)
port-channel channel-id (Range: 1-27)
vlan vlan-id (Range: 1-4094)
Default Setting
None
Command Mode
Global Configuration
transceiver-threshold
rx-power Sets thresholds for the transceiver power level of the
received signal which can be used to trigger an alarm or
warning message IC
transceiver-threshold
temperature Sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message IC
transceiver-threshold
tx-power Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or
warning message IC
transceiver-threshold
voltage Sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message IC
show interfaces transceiver Displays the temperature, voltage, bias current, transmit
power, and receive power PE
show interfaces transceiver-
threshold Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power PE
Cable Diagnostics
test loop internal Performs an internal loop back test on the specified port PE
show loop internal Shows the results of a loop back test PE
Table 69: Interface Commands
(Continued)
Command Function Mode