Edge-Core AS5700-54X, Cli Reference Manual, Page: 155 / 1116

Chapter 4
| System Management Commands
Event Logging
– 155 –
logging host
This command adds a syslog server host IP address that will receive logging
messages. Use the
no form to remove a syslog server host.
Syntax
logging host host-ip-address [ port udp-port ]
no logging host host-ip-address
host-ip-address - The IPv4 or IPv6 address of a syslog server.
udp-port - The UDP port number used by the remote server.
(Range: 1-65535)
Default Setting
UPD Port: 514
Command Mode
Global Configuration
Command Usage
◆
Use this command more than once to build up a list of host IP addresses.
◆
The maximum number of host IP addresses allowed is five.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The
no form disables the logging process.
Syntax
[ no ] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent to
remote syslog servers. You can use the
logging history command to control the
type of error messages that are stored in memory. You can use the logging trap
command to control the type of error messages that are sent to specified syslog
servers.